G7SA

Связаться с отделом продаж

Реле с механически связанными контактами

Семейство миниатюрных реле G7SA с механически связанными контактами объединяет 4-полюсные и 6-полюсные модели с различными комбинациями контактов и усиленной изоляцией. Специальное расположение выводов упрощает монтаж на печатную плату. Реле G7SA допускают монтаж пайкой или установку в монтажные колодки P7SA.

Механически связанные контакты.
Соответствие EN 50205.
6 A при 240 В~ и 6 A при 24 В= для резистивной нагрузки.
Усиленная изоляция между входами, выходами и полюсами.
4-полюсные и 6-полюсные модели.
Доступны монтажные колодки с безвинтовыми клеммами «Push-in»

Ordering information

Relays with forcibly guided contacts

Type	Sealing	Poles	Contacts	Rated voltage	Order code
Standard	Flux-tight	4 poles	3PST-NO, SPST-NC	24 VDC1	G7SA-3A1B
		4 poles	DPST-NO, DPST-NC		G7SA-2A2B
		6 poles	5PST-NO, SPST-NC		G7SA-5A1B
			4PST-NO, DPST-NC		G7SA-4A2B
			3PST-NO, 3PST-NC		G7SA-3A3B

Sockets

Mounting	Terminal type	LED indicator	Poles	Coil rated voltage	Order code
Front- mounting	Push-In Plus terminals	Yes	4 poles	24 VDC	P7SA-10F-ND-PU
	Push-In Plus terminals	Yes	6 poles		P7SA-14F-ND-PU
	Screw terminals	Yes	4 poles		P7SA-10F-ND
		Yes	6 poles		P7SA-14F-ND
		No	4 poles	−	P7SA-10F
		No	6 poles	−	P7SA-14F
Back- mounting	PCB terminals	No	4 poles	−	P7SA-10P
Back- mounting	PCB terminals	No	6 poles	−	P7SA-14P

Specifications

Coil

Rated voltage	Rated current	Coil resistance	Must-operate voltage	Must-release voltage	Max. voltage	Power consumption
24 VDC	4 poles: 15 mA 6 poles: 20.8 mA	4 poles: 1,600 Ω 6 poles: 1,152 Ω	75% max. (V)	10% min. (V)	110% (V)	4 poles: Approx. 360 mW 6 poles: Approx. 500 mW

Rated voltage

Rated current

Coil resistance

Must-operate voltage

Must-release voltage

Max. voltage

Power consumption

24 VDC

4 poles: 15 mA

6 poles: 20.8 mA

4 poles: 1,600 Ω
6 poles: 1,152 Ω

75% max. (V)

10% min. (V)

110% (V)

4 poles: Approx. 360 mW
6 poles: Approx. 500 mW

Note: Refer to datasheet for details

Contacts

Load	Resistive load (cos φ = 1)
Rated load	6 A at 250 VAC, 6 A at 30 VDC
Rated carry current	6 A
Max. switching voltage	250 VAC, 125 VDC
Max. switching current	6 A
Max. switching capacity (reference value)	1,500 VA, 180 W

Relays with forcibly guided contacts

Contact resistance		100 mΩ max. (The contact resistance was measured with 1 A at 5 VDC using the voltage-drop method.)
Operating time 2		20 ms max.
Response time 1		10 ms max. (The response time is the time it takes for the normally open contacts to open after the coil voltage is turned OFF.)
Release time 1		20 ms max.
Insulation resistance		100 MΩ min. (at 500 VDC) (The insulation resistance was measured with a 500 VDC megger at the same places that the dielectric strength was measured.)
Dielectric strength 3 4		Between coil contacts/different poles: 4,000 VAC, 50/60 Hz for 1 min (2,500 VAC between poles 3-4 in 4-pole Relays or poles 3-5, 4-6, and 5-6 in 6-pole Relays.) Between contacts of same polarity: 1,500 VAC, 50/60 Hz for 1 min
Durability	Mechanical	10,000,000 operations min. (at approx. 36,000 operations/hr)
	Electrical	100,000 operations min. (at the rated load and approx. 1,800 operations/hr)
Min. permissible load5		5 VDC, 1 mA (reference value)
Ambient temperature 6		Operating: −40 to 85°C (with no icing or condensation)
Ambient humidity		Operating: 35 to 85%
Approved standards		EN61810-1 (IEC61810-1), EN50205, UL508, CSA22.2 No. 14

Note: The values listed above are initial values.

Please check Omron in the Internet for updated information on product reliability data and the SISTEMA libraries: http://industrial.omron.eu/safety

1. 12 VDC, 21 VDC, 48 VDC are available on request.

2. These times were measured at the rated voltage and an ambient temperature of 23°C. Contact bounce time is not included.

3. Pole 3 refers to terminals 31-32 or 33-34, pole 4 refers to terminals 43-44, pole 5 refers to terminals 53-54, and pole 6 refers to terminals 63-64.

4. When using a P7SA socket, the dielectric strength between coil contacts/different poles is 2,500 VAC, 50/60 Hz for 1 min.